132996260.qxd 7/24/01 9:12 PM Pagina 45

(Nero/Process Black pellicola)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Installation

Water inlet (cold water connection only)

Connect the hose

to a tap with a 3/4” thread.

Installation

should comply with local water authority and

building regula- tions’ require- ments.

Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.

Do not connect to a hot water supply.

The inlet hose is provided with a water stop device, which protects against damage caused by water leaks in the hose which could develop due to natural ageing of the hose. This fault is shown by a red sector in

the window “A”. Should this occur, turn the A water tap off and refer to your Service Force Centre to replace the hose.

Water drainage

The appliance drain hose should hook into a standpipe, the hook in the drain hose is formed using the plastic “U-Piece” supplied. The standpipe should have an internal diameter of approximately 38 mm (see dia- gram) thus ensuring there is an air break between the drain hose and standpipe.

When discharging into a stand- pipe ensure that the top of the curve in the hose end is no more than 90 cm (35.4”) and no less than 60 cm (23.6”) above floor level.

3 pin

Max. 90 cm.(35.4")

Min.60 cm.(23.6")

45

Page 45
Image 45
AEG 10500 VI manual Water inlet cold water connection only, Water drainage, Do not connect to a hot water supply