How to wash
Starting the programme
1. Check that the water tap is open.
2. Press START/PAUSE to start the programme. If the Delay Start option has been selected the programme will start at the end of the count-
down. |
|
If the door light | is red and flashing at the start of the pro- |
gramme it indicates that the door is open. Close the door and press the START/PAUSE button again.
If the delay start option has been selected, the machine starts its countdown, in hours, which will appear on the display. During this period it is possible to load other laundry, to modify or cancel the delay time.
•Load other laundry: press the START/PAUSE button. Open the door. Load the laundry. Close the door and press the START/PAUSE button again.
•Modify or cancel the delay time: press the START/PAUSE button.
Press the DELAY START button 
until the time required appears on the display, or 0h, if you wish to cancel it. Press the START/ PAUSE button again.
How to wash
amount, type, degree of soil of fabrics and water hardness.
This light could come on also when the drain filter is blocked.
If the RINSE HOLD 
option has been selected, the water must be emptied out before opening the door either
-by pressing the START/PAUSE button (the laundry will be spun at the speed corresponding to the selected type of fabrics. The spin speed can be reduced by means of the SPIN SPEED button)
-or by turning the selector dial to O and then to DRAIN “C” and pressing the START/PAUSE button again. In this case the water will be emptied, but the laundry is not spun.
Turn the selector dial to O. Remove the laundry from the drum.
Check that the drum is empty so as to avoid any forgotten items being damaged in a subsequent wash (e.g. shrinking) or their colour running into a load of whites.
Close the water tap.
Leave the door open to prevent the formation of mildew and unpleas- ant smells.
Programme progress display
By selecting the wash programme, the pilot lights corre- sponding to the various phases making up the programme come on. After the machine has started, only the running phase pilot light stays on.
Display
PREWASH
MAIN WASH
RINSES 
EXTRA RINSE 
SPIN
DRYING
END
OVERDOSAGE
Automatic washing and drying
(NON-STOP programme)
Warning! For
If you use a dosing device in a
Load the laundry.
Add detergent and additive.
Select the wash programme.
The time to the end of the programme decreases minute by minute and appears on the display.
At the end of the programme
The machine stops automatically. A zero appears on the display. An acoustic signal is clearly audible. The END 
light comes on in the pro- gramme progress display.
If the light 
(OVERDOSAGE) comes on it indicates that too much detergent has been used. At the next wash carefully follow the deter- gent manufacturer’s instructions. Measure out detergent according to
28
Select eventually the required options by means of the relevant buttons. If possible, do not select a spin speed lower than that proposed by the appliance to avoid a too long drying time so saving energy.
By automatic washing and drying it is not possible to select a spin speed lower than 900 r.p.m. for cottons and 700 r.p.m. for synthetics.
Select the drying time or degree of drying.
Start the programme by depressing the START/PAUSE button. At the end of the programme, turn the selector dial to O. Remove the laundry.
29
