132994110gb.qxd 11-04-2002 16:06 Pagina 95

Installation

Unpacking

All transit bolts and packing must be removed before using the appli- ance.

Using a spanner, unscrew and remove the rear right-hand bolt and lay the machine on its back, taking care not to squash the hoses. This can be avoided by placing one of the corner packing pieces between the machine and the floor.

Remove the poly-

 

styrene block from

 

the bottom of the

2 1

machine and

release the two

plastic bags.

Carefully remove the right-hand bag (1)

then the left-hand

bag (2) by pulling them towards the centre of the machine.

Set the machine upright and remove the two remaining bolts from the back.

Pull out the three

plastic spacers from the holes into which

the bolts were fitted.

Plug the open holes

with the plugs which you will find in the plastic bag containing

the instruction booklet.

You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.

95

Page 95
Image 95
AEG 16810 manual Unpacking, Bolts were fitted Plug the open holes