AEG 204-4 GS, 2073-4 GS manual Door reversibility

Door reversibility

Unplug the freezer before performing the following operations:

Remove the ventilation grill (D).

Remove the lower hinge (E) by loosening the two fastening screws.

	Fig. 2
E	F
F
	F
D
F
PR185

Remove the door by sliding it out of the upper pin (A- Fig. 3).

Unscrew the pin and the washer (A+B-Fig. 3) and refit them on the opposite side.

Refit the door.

Refit the lower hinge (E-Fig. 2) on the opposite side by means of the two screws that have been previously removed.

Remove the plug (F) from the ventilation grill (D) and replace it on the opposite side.

Refit the ventilation grill.

Remove the handle and refit it on the opposite side (Fig. 4).

Unscrew the handle. Refit it on the opposite side after having pierced the plugs with a punch. Cover the holes left open with the plugs contained in the documentation pack.

If, after having reversed the door, it is not in line with the unit, the top hinge can be adjusted.

To do this, use a 10 mm spanner as shown in Figure 3; slacken the nut, align the door by pushing it to the left or right, then re-tighten the nut.

Attention

After having reversed the opening direction of the door check that all the screws are properly tightened and that the magnetic seal adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier.

Fig. 3

C

B

A

D427

Fig. 4

PR228

39