K - Electrical wiring diagrams and instructions
WARNING:
All aspects of the installation must conform with the requirements of the standard North America (within North America) wiring rules, as well as your local electrical and building codes and regulations, and any other applicable requirements and conditions of your local power supply authority.
A licensed electrician must perform the electrical work when installing this appliance. The supply cable and fuse rating must be suitable for the appliance.
240 Volt 60hZ 30AMP single/40AMP double service
WARNING:
A licenced electrician must connect the armour cable and 3 wires into the electrical connection box. The white, or Neutral wire is not used, and must be capped using a marette.
To avoid power borne interference, this appliance must be installed individually on a separate and distinct final
Note:
To the electrician – please ensure sufficient supply cable is provided to allow the appliance to be removed from the cavity should any servicing be necessary. This will also allow easy connection of the supply.
Voltage supply connection To connect the electrical supply:
1- Ensure the supply cable and fuse rating are suitable for the appliance (see the electrical loading).
2- Remove the cover plate by undoing the screw.
3- Fit a suitable entry bush to the conduit entry on the rear left of the appliance (with the rear toward you) and feed the fixed wiring through.
4- Connect the wiring to the terminal block using the screw connections provided. Ensure the wires are properly secured to prevent any high resistance electrical connection.
5- Replace the cover plate making certain that the supply wiring is clear of any metal work and the screws.
When connected to a sub circuit, protected by a circuit breaker, it is recommended the circuit breaker be the same as the total rating of the appliance.
Electrical Loads |
|
Oven | 2900 W |
Grill | 2700 W |
Oven fan and light | 100 W |
