F - Ceramic Cooktop Functions
WARNING
All operations relative to installation and electric connection should be carried out by qualified personnel in conformity with the regulations in force in your country.
The specific instructions are described in the booklet section for the installer
NOTICE
∙Use only flat pans with a sufficiently thick base, equal to or not much larger than the hot plate selected (fig.1)
∙The containers should not have rough bottoms in order to avoid scratching the heat surface of the top.
∙Do not switch the electric plate on without the pan over the plate.
∙Do not cook any food directly on the hot area. Avoid overflows of liquid and should they occur clean away promptly.
∙Turn off the plate few minutes before the cooking end.
Switching on
Set the power by rotating the knob, taking into consideration that the highest number corresponds with the maximum power.
The pilot light is switched ON when at least one element is on. The residual heat indicator will light up when the temperature in any area is higher than 50OC.
Cleaning
Remove leftover and grease or spillage from the cooking surface with the special scraper (fig.3) (optional).
Then clean the heating area thoroughly with a paper towel and ceramic cleaning products for the correct care of your appliance. Never use abrasive sponge or irritating chemical detergents such as over spray or spot removers.
