![](/images/new-backgrounds/1068947/6894735x1.webp)
Securing the hob into the cut out
Before fitting the hob into the cut out, the sealing gasket supplied with the hob must be fitted to the edge of the cut out. It is essential that no gaps are left in this seal in order to prevent spillage near the hob seeping into the cabinet below.
1)Place the sealing gasket (A) all around the edge of
the cut out.
2)Fit the hob in the cut out and push it down until it comes in contact with the kitchen top surface.
The remove the excess sealing.
3)To remove the hob from the
Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated.
The recommended solution is shown in diagram.
The panel fitted under the hob should be easily removable to allow easy access if technical assistance is needed.
| 30 |
Removable | 5020 min |
| |
panel |
|