Operating Instructions
What to do, if ...
Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call an engineer to resolve a of fault listed here, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee.
...Error messages
•If the programme indicator for the selected wash programme is flashing and fault code (1 or (2 is displayed on the
After rectifying this fault, press the button for the wash programme that has been started. The wash programme continues. If the fault code is displayed again, contact customer service.
•For all other faults, please contact customer service, stating the fault code.
Symptom | Possible Cause | Solution | |
Fault code (1 is dis- | Tap is blocked or furred with | Clean tap. | |
played on the multi- |
| ||
display. | The filter (where present) in |
| |
The programme indica- | Clean the filter in the | ||
tor for the selected | the threaded hose fitting is | threaded hose fitting. | |
blocked. | |||
wash programme is |
| ||
|
| ||
flashing: |
|
| |
there is no water run- | The water inlet hose is not | Check hose installation. | |
ning into the dish- | correctly laid. | ||
| |||
washer. |
|
| |
Fault code (2 is dis- | The sink outlet is blocked. | Clean the sink outlet. | |
played on the multi- |
|
| |
display. |
|
| |
The programme indica- | The water drain hose is not | Check hose installation. | |
tor for the selected | correctly laid. | ||
wash programme is |
| ||
|
| ||
flashing. |
|
| |
Fault code (3 is dis- | The leak prevention system | Close the tap and contact | |
played on the multi- | your local AEG Sevice Force | ||
has been triggered. | |||
display. | Centre. | ||
| |||
|
|
|
28
