Installation and Connection Instructions
| Leak Prevention System |
| For protection from damage due to water leaks, the dishwasher is |
| equipped with a leak prevention system, the AQUA CONTROL SYSTEM. |
| In the event of a fault, the safety valve immediately interrupts the sup- |
| ply of water to the appliance and the drain pump switches on. By this |
| means water can neither escape nor overflow. The remaining water in |
| the appliance is automatically pumped out. |
1 | The AQUA CONTROL SYSTEM also works when the appliance is switched |
| off – the appliance must however not be disconnected from the mains. |
Electrical Connection
| Any electrical work required to install this appliance should be car- |
| ried out by a qualified electrician or competent person. |
1 | WARNING - This appliance must be earthed. |
| The manufacturer declines any responsibility should these safety |
measures not be observed.
Before switching on make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.
To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.
Changing a fuse
The appliance is supplied with a 13amp plug fitted. In the event of hav- ing to change the fuse in the plug supplied, a 13amp ASTA approved (BS 1363A) fuse must be used.
Should the plug need to be replaced for any reason, proceed as described below.
The wires on the mains lead are coloured in accordance with the following code.
Green
& Yellow
BlueBrown
Green and Yellow : Earth
Blue | : Neutral |
Brown | : Live |
Cord Clamp
36
