Manuals / AEG / Kitchen Appliance / Dishwasher

AEG 54710 operating instructions Installation, Levelling, Proceed as follows

Models: 54710

1 38

Download 38 pages 56.44 Kb

Page 34

Installation

Installation

Fitting under a counter (kitchen worktop or sink)

By removing the machine’s worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture.

Proceed as follows:

-Remove the machine’s worktop by unscrewing the two front retaining screws, pull from the front and slide out the rear slots, lifting the worktop.

570-

600

820

450

IN04

34

Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.

Levelling

Good levelling is essential for correct closure and sealing of the door.

When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet.

If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.

Image 34

AEG 54710 operating instructions Installation, Levelling, Proceed as follows

Contents

Dishwasher FAVORITOperating instructions Page Contents Before using your dishwasher for the first time Safety instructionsUsing your dishwasher for its intended purpose Child safetyYour dishwasher in day-to-dayuse Disposing of the packaging Disposing of packaging and old machineDisposing of your old machine Economical and ecological dishwashing Upper basket Description of the applianceThe inside of the appliance IN1384.Door handle 5.On/Off indicator light 2.Delay start push button3. Indicator lights Phase indicator lightsBefore using your dishwasher for the first time Setting the water hardness range1 flash Filling with special salt To fillindicator light will illuminate only in setting Rinse aidFilling with rinse aid compartment. Clean up any rinse aid spilt duringSO500 programme indicator light starts to flashSO502 Adjusting the dose BR02Loading cutlery and dishes The lower basket To lower the prongsCutlery basket Adjusting the height of the upper basket The upper basketIf using detergent in tablets proceed as follows If using powder detergents proceed as followsUse of detergent Compact detergents with enzymes Washing programmes Cycle description Approximate values2. Press the On/off push button Operating instructions1. Check the filters 3. Check that there is rinse aid and salt9. To cancel a programme in progress 10. At the end of the washing programmeIn general it is not advisable to open the door while the machine is working if the door is opened however, a safety device ensures that the machine stops Internal and external cleaning Maintenance and cleaningCleaning the filters The dishwasher must not be used without filters What to do, if Visible lime deposits or white film on the dishes The dishes are not cleanthe wash results are not satisfactory The dishes are not quite dryCustomer service Technical specifications Hints for test centres Levelling InstallationProceed as follows Water supply connections Connection instructionsWater outlet connection Extension hosesProtection against flooding Electrical connection152976 12/1 AEG Hausgeräte GmbH Postfach D-90327NürnbergSubject to change without notice