36

Water outlet connection

The end of the drain hose can be connected as follows:

1.To the sink outlet siphon, securing it if necessary with a clip.

2.Hooked over the edge of the sink using the special curved plastic guide provided.

3.To a wall outlet provided with vent-hole, minimum internal diameter 4 cm.

 

 

1

2

3

Ø

21

 

 

4 cm

 

 

min

 

18

 

 

Ø

 

 

 

 

 

 

 

 

 

max 100 cm

min 30 cm max 100 cm

CS09

 

 

 

 

The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the floor.

It makes no difference which way the drain hose faces, either to the right or left of the dishwasher.

Avoid bending or kinking the hose as this could prevent or slow down the discharge of water.

Extension hoses

The necessary extension hoses can be obtained from specialist shops or from our technical assistance centres.

The extension hose must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided.

Likewise the internal diameter of the couplings used for connection to the waste outlet must be no smaller than the diameter of the drain hose.

Arrange the extension hose horizontally along the floor and allow it to rise only where it is to be connected to the drain.

Ø 18

Ø 21

 

 

 

 

cm

min 30 cm max 100 cm

+ 2 m max

max 100

 

 

CS10

 

 

 

Page 36
Image 36
AEG 54710 operating instructions Water outlet connection, Extension hoses