16Use
Changing a running programme is possible only by resetting it. Turn the programme selector dial to «O» and then to the new programme position. Start the new programme by pressing the Start/Pause button again. The washing water in the tub will not emptied out.
Interrupting a programme
Press the Start/Pause button to interrupt a programme which is running, the corresponding light starts to flash. Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to «O» to cancel a programme which is running. Now you can select a new programme.
Opening the door after the programme has started
First set the machine to pause by pressing the Start/Pause button.
After some minutes the door can be opened.
If the door remains locked, this means that the machine is already heating, that the water level is above the bottom edge of the door. In this case the door can not be opened.
If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to «O» . After about a few minutes the door can be opened (pay attention to the water level and temperature!).
After closing the door, it is necessary to select the programme again and to press the Start/Pause button.
At the end of the programme
The machine stops automatically. The Start/Pause and «HOOFDWAS LAVAGE» (Functioning) lights go off and the phase light «EINDE FIN DE CYCLE» (End) illuminates.
If the Rinse Hold 
option has been selected, the light 
remains lit, the phase light «EINDE FIN DE CYCLE» (End) illuminates, the door remains locked to indicate that the water must be emptied out before opening the door.
To empty out the water please read the steps on the Rinse Hold option paragraph.
Turn the programme selector dial to «O» to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty.
If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells.
