What to do if...

Remedying small malfunctions

If one of the following fault codes is displayed in the multi-display during operation:

–Fault codeÅ 10 (Problems with water inlet),

–Fault codeÅ 20 (Problems with water drainage), please have a look at the following table.

When the fault is remedied, press the button for the cycle that has started. The cycle will continue.

With other fault codes (“Å ” followed by a number):

–Abort the dishwashing cycle.

–Switch the appliance off and on again.

–Re-set the dishwashing cycle.

If the fault is displayed again, please contact your local Service Force Centre and inform them of the fault code.

Malfunction

Possible cause

Remedy

 

Water tap is blocked with

Check the water tap and

 

limescale or faulty.

have it repaired if necessary.

 

The tap is turned off.

Turn the tap on.

The cycle indicator for the

The filter (where present) in

Clean the filter in the

selected dishwashing cycle

the threaded hose fitting

threaded hose fitting.

on the tap is blocked.

is flashing:

 

 

the control indicator WA-

 

Cancel the dishwashing cy-

TER is lit,

 

cle (see chapter: Starting a

fault code Å 10 is dis-

Filters in the base of the

dishwashing cycle),

played in the multi-display

washing compartment are

clean filters (see chapter:

(Problems with water in-

blocked.

Cleaning the filters),

let).

 

then start the dishwashing

 

 

cycle again.

 

Water inflow hose

Check the position of the

 

has not been correctly posi-

 

tioned.

hose.

 

 

The cycle indicator for the

The sink outlet is blocked.

Clean out sink outlet.

selected dishwashing cycle

 

 

 

 

is flashing,

 

 

fault code Å 20 is dis-

Water drain hose

Check the position of the

played in the multi-display

has not been correctly posi-

(there is water in the dish-

tioned.

hose.

washer’s internal dispens-

 

 

er).

 

 

 

 

 

30