Operating instructions
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes in the upper and/or lower rack, an intelligent electronic system adjusts the amount of water and the duration of the wash programme to the number of dishes. By this means it is possible to wash only a few dishes quickly and economically. At half load (6 place settings), up to 2 litres of water and 0.2 kWh of electricity are saved.
Switching Off the Dishwasher
Only switch the dishwasher off when the
0 1. Press the ON/OFF buttonindicator extin- guishes.
1 | Hot steam may escape from the appliance when opening the door |
| immediately after the end of the programme. Therefore: |
2.Open the door carefully.
| Emptying the Dishwasher |
3 | • Hot dishes are sensitive to knocks. The dishes should therefore be |
| allowed to cool down before removing them from the appliance. |
• The dishes will dry quicker if, when the programme has finished, you briefly open the door fully and then leave it slightly ajar.
• Leave the dishes in the dishwasher for approx. 15 minutes after the end of the programme so that they dry better and can cool down.
• First empty the lower rack, and then the upper rack. By using this procedure you will avoid any water that may be remaining in the upper rack, dripping onto the dishes in the lower rack and leaving water marks.
25
