Installation and Connection Instructions
Connecting the Dishwasher
Water connection
The dishwasher is fitted with safety devices that prevent the return of wash water into the drinking water system and comply with the appli- cable plumbing regulations.
•The dishwasher can be connected to cold and hot water supplies up to max. 60 °C.
•The dishwasher must not be connected to open hot water appliances or instantaneous water heaters.
Permitted water pressure
Lowest permitted water pressure: | For a water pressure of less than 2 bar |
1 bar (=10N/cm2 =100 kPa) | please seek advice from customer service. |
Highest permitted water pressure: | In the case of a water pressure greater |
10 bar (=100 N/cm2 =1 MPa) | than 10 bar, a pressure reduction valve |
| must be used (available from your |
| dealer). |
|
|
| Connect the inlet hose |
1 | The water inlet hose must not be kinked, crushed or entangled when it |
| is being connected up. |
0Connect the threaded hose fitting (DIN 259) on the water inlet hose to a tap with an external thread (¾ inch). Tighten the threaded hose fit- ting only by hand.
3 | • In order that access to the tap in the kitchen is not limited by the use |
| of the dishwasher, we recommend the installation of an additional |
tap, or the fitting a two way adapter to the existing tap.
• If you need a longer water inlet hose than that supplied, the follow- ing VDE approved complete hose sets are to be used, these are availa- ble from your dealer:
– Hose set "WRflex 100" (E No.: 911 239 034)
– Hose set "WRflex 200" (E No.: 911 239 035)
35
