Operating instructions
...Error Messages Are Displayed.
•If fault code (2 is displayed on the
After rectifying a (2 fault and a fault related to the ^ indicator, press the button for the wash programme that has been started. The wash programme continues. If the fault code is displayed again, con- tact customer service.
•For all other faults, please contact customer service, stating the fault code.
Malfunction | Possible Cause | Remedy | |
The programme indica- | Tap is closed. | Open tap. | |
tor for the selected | The filter (where present) in |
| |
programme is flashing |
| ||
the threaded hose fitting at | Clean the filter in the | ||
and the ^indicator is | |||
the water inlet valve is | threaded hose fitting. | ||
illuminated: | |||
blocked. |
| ||
there is no water run- |
| ||
|
| ||
ning into the dish- | The water inlet hose is not | Check hose installation. | |
washer. | correctly laid. | ||
| |||
Fault code (2 is dis- | The siphon is blocked. | Clean siphon. | |
played on the multi- |
|
| |
display. |
|
| |
The programme indica- | The water drain hose is not | Check hose installation. | |
tor for the selected | correctly laid. | ||
wash programme is |
| ||
|
| ||
flashing. |
|
| |
Fault code (3 is dis- | The leak prevention system | Close the tap and contact | |
played on the multi- | |||
has been triggered. | customer service. | ||
display. | |||
|
| ||
|
|
| |
| The [ indicator is only |
| |
| intended to remind you to |
| |
| check the filter in the dish- | The indicator goes out auto- | |
The [ indicator is | washer from time to time | ||
and, if necessary, to clean it. | matically on the start of the | ||
illuminated. | |||
It illuminates at regular | next wash programme. | ||
| |||
| intervals, independent of the |
| |
| amount of soiling of the fil- |
| |
| ter. |
| |
|
|
|
28