22 www.aeg.com
INSTALLATION
APPLIANCE POSITIONING
•The tumble dryer must be installed in a clean position, where dirt does not col- lect.
•Air must flow freely around the appli- ance. Make sure that the front airflow slots in the bottom of the appliance are not blocked .
•To keep vibration and noise at the mini- mum, when the tumble dryer operates, it must be put on a stable and flat sur- face.
•When the appliance is put in its perma- nent position, check if is fully level with the aid of a spirit level. If it is not, adjust the feet until it is.
15mm |
UNPACKING |
CAUTION! |
•Do not remove the feet. Do not de- crease the floor clearance through thick carpets, bar of wood or equivalent. This can increase the heat which can cause interference with the operation of the appliance.
• The temperature of the hot air which occurs in the tumble dry- er can increase to 60 °C. The appliance must not be installed on the floor which is not resist- ant to high temperatures.
•When the tumble dryer oper- ates, the room temperature must not be lower than +5 °C and higher than +35 °C. This can cause unwanted effect on the performance of the appli- ance.
•If it is necessary to move the ap- pliance, it must be moved verti- cally.
•The appliance must not be in- stalled behind a lockable door, a sliding door, a door with a hinge on the opposite side to that of the appliance in such a way that a full opening of the tumble dryer is restricted.
It is possible to adjust the height of the tumble dryer. To do that adjust the feet (see picture).
Before use all parts of the transport pack- aging must be removed.
To remove the polystyrene blockages:
1.Open the load door.
2.Pull plastic hose with the polystyrene blockages out from the drum.
INSTALLATION UNDER A COUNTER
The appliance can be installed as free- standing or below the kitchen counter with correct space (see picture).
