HINTS AND TIPS
ECOLOGICAL HINTS
•Do not use fabric softener to wash and then dry. In the tumble dryer laundry becomes soft automatically.
•Use the condensate as distilled water, e.g. for steam ironing. If necessary clean the condensate before (e.g. with a coffee filter) to remove possible small pieces of fluff.
•Always keep the airflow slots on the bottom of the appliance clear.
•Use the load volumes specified in the programmes chapter.
•Make sure that is good airflow in the appliance installation position.
•Clean the filter after each drying cycle.
•Spin good the laundry before drying.
WATER HARDNESS AND
CONDUCTIVITY
Water hardness can be different for differ- ent locations. Water hardness has an ef- fect on the water conductivity and the op- eration of the conductivity sensor in the appliance. If you know the value of the water conductivity you can adjust the sen- sor to dry with the better results.
To change the sensor conductivity:
1.Turn the programme dial to available programme.
2.Push at the same time the Delicate and Anticrease buttons and hold down until one of the these symbols go into view on the display:
– | low conductivity <300 μS/ |
cm
–
moderate conductivity
–
high conductivity >600 μS/ cm
3.Push the Start Pause button again and again until you set necessary lev- el.
4.To memorise setting push at the same time the Delicate and Anti- crease buttons.
ENGLISH 13
WATER CONTAINER FULL — INDICATION
By default the indication LED is always on. It comes into the view at the end of the cycle or when the water container is full. When you use an external equipment to drain the container, the LED can be off. To activate or deactivate the indication:
1.Turn the programme dial to available programme.
2.Push at the same time the Delicate and Delay Start buttons and hold down until you see the correct set- ting:
– the LED is off and the symbol
goes into the view - The LED is permanently off
– the LED is on and the symbol
goes into the view - The LED is activated
