AEG 72640 manual Set the delay timer / soaking duration Delay timer, Soaking duration

Operating Instructions

Set the delay timer / soaking duration

	Delay timer
	The b (DELAY TIMER) button allows the start of a washing program to
	be postponed for between 1 and maximum 19 hours.
0	To do this, press the b (DELAY TIMER) button as
	often as necessary until the required start delay is
	shown in the multi display, for example in the
	form12h for the postponement of the program
	start of 12 hours.
	If19h is displayed and you press again,
	0h appears, followed by the run time of the set program
	(display in minutes, e.g. 126). No delay timer is set in this state.
3	Once the delay timer has been set, it will only be activated after press-
	ing the O/s (START/PAUSE) button.

	Soaking duration
	When the q(SOAKING) button is pressed, you can extend the soaking
	period with the b (DELAY TIMER) button (maximum 10 hours and ap-
	prox. 20 minutes).
3	Without delay timer, the soaking period is approximately 30 minutes,
	plus a pre-wash time of 20 minutes.

0To adjust, press the b (DELAY TIMER) button as often as necessary until the required soaking period is shown in the multi display, e.g.1h

(=1 hour).

After approximately 2 seconds, the multi display shows the run time in minutes.

	This run time is made up as follows:
	Selected soaking period	e.g.	ih= 60	Minutes
	+ Heating-up/pre-wash time	e.g.	Approx. 20	Minutes
	+ Run time of the selected wash program	e.g.	Approx. 126	Minutes
	= Displayed value	e.g.	Approx. 206	Minutes
3	While q(SOAKING) is running, k(PRE-WASH) lights up on the
	program sequence display.

20