152963991en per CH.qxp 03/08/2004 13.39 Pagina 33
Operating instructions
What to do, when...
Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions given here, without calling out an engineer.
...alarm messages or codes are displayed
The dishwasher will not start or stops during operation.
The intervention of an alarm is indicated by:
-a continous sequence of intermittent audible signals
-the
dishwasher’s door is flashing.
Open the dishwasher’s door, a message or a code (as indicated in the following chart) is displayed.in digital display is visible a fault code (see following chart).
Carry out the following suggested corrective actions.
Fault code / message
in the digital display appears
“OPEN THE TAP”
The machine does not fill with water
in the digital display appears
“DRAIN BLOCKED”
The dishwasher will not drain
Possible cause
The water tap is blocked or furred with limescale.
The water tap is turned off.
The filter (where present) in the threaded hose fitting at the water inlet valve is blocked.
The water inlet hose has not been correctly laid or it is bent or squashed.
The siphon is blocked.
The water drain hose has not been correctly laid or it is bent or squashed.
Solutions
Clean the water tap.
Turn the water tap on.
Clean the filter in the threaded hose fitting.
Check the water inlet hose connection.
Clean out the siphon.
Check the water drain hose connection.
in the digital display | Protection against flooding is | Close the water tap and |
appears | active. | contact your local Service |
|
| Force Centre. |
33