Installation on a not hard floor
When you install the appliance on a not hard floor (wooden planks floor), put a rigid support plinth under the appli- ance feet to prevent the noise and the vibration.
Assemble the plinth with a waterproof wood panel (min. 15 mm thick) and at-
ENGLISH 33
tach it to the beams of the floor with minimum 2 screws.
The plinth must extend of some cm more than the edges of the appliance. We recommend you to install the appli- ance in one of the corners of the room, where the floor is more stable.
THE INLET HOSE
45O |
35O |
•Connect the hose to the appliance. Turn the inlet hose only left or right. Loose the ring nut to set it in the cor- rect position.
•Connect the water inlet hose to the cold water tap with 3/4 thread.
CAUTION!
Make sure that there are no leaks from the couplings.
Do not use an extension hose if the inlet hose is too short. Con- tact the service centre for the re- placement of the inlet hose.
Water pressure
The appliance works correctly if the wa- ter pressure is not less than 0.05 MPa (0.5 bar).
If you can not connect the water inlet hose to the cold water tap of the pri- mary hydraulic system, connect it to your domestic cold water storage sys- tem.
Make sure not to have more than a dis- tance of 5.02 m (16.5 ft) between the appliance inlet hose and the bottom of the water storage tank.
