Problem Possible cause Possible solution
You did not remove the stub-
born stains before you wash
the laundry.
Use special products to remove the
stubborn stains.
You set a not correct tempera-
ture.
Make sure that you set the correct tem-
perature.
Too much laundry load. Decrease the laundry load.
The internal lamp is
off.
The lamp is burned. To replace the lamp, contact the service
centre.
After a steam pro-
gramme, garments are
partially wet.
The appliance is not accurately
levelled.
Check the levelling and adjust the appli-
ance by raising or lowering the feet.
After a steam pro-
gramme, garments are
not sufficiently
smooth.
A wrong STEAM programme
has been selected (e.g. Syn-
thetic instead of Cotton).
Note the composition of the fabric.
Excessive laundry load. Reduce the laundry load
The drum is empty
and the display shows
there is some weight
in .
It is necessary to set a tare. Press button
1
to deactivate the appli-
ance and to activate it again.
The drum is full but
the display shows 0.0
kg.
You loaded the laundry before
to activate the appliance.
Press button
1
to deactivate the appli-
ance . Empty the drum and obey to the
necessary steps. (Refer to 'Loading the
laundy')
After the check, activate the appliance. The programme continues from the point of inter-
ruption.
If the problem occurs again, contact the service centre.
If the display shows other alarm message, contact the service centre.
Service• Refer to the information supplied with
this appliance for guarantee condition
and point of contact. The information to
give to the service is on the rating plate.
We recommend that you write the information here:
Model
(MOD.)
..................