INSTALLATION
APPLIANCE POSITIONING
•The tumble dryer must be installed in a clean position, where dirt does not collect.
•Air must flow freely around the appli- ance. Make sure that the front airflow slots in the bottom of the appliance are not blocked .
•To keep vibration and noise at the minimum, when the tumble dryer op- erates, it must be put on a stable and flat surface.
•When the appliance is put in its per- manent position, check if is fully level with the aid of a spirit level. If it is not, adjust the feet until it is.
•Do not remove the feet. Do not de- crease the floor clearance through thick carpets, bar of wood or equiva- lent. This can increase the heat which can cause interference with the oper- ation of the appliance.
• The temperature of the hot air which occurs in the tumble dryer can increase to 60 °C. The appliance must not be in- stalled on the floor which is not resistant to high tempera- tures.
•When the tumble dryer oper- ates, the room temperature must not be lower than +5 °C and higher than +35 °C. This can cause unwanted effect on the performance of the appli- ance.
•If it is necessary to move the appliance, it must be moved vertically.
•The appliance must not be in- stalled behind a lockable door, a sliding door, a door with a hinge on the opposite side to that of the appliance in such a way that a full open- ing of the tumble dryer is re- stricted.
ENGLISH 21
UNPACKING
CAUTION!
Before use all parts of the transport packaging must be removed.
1.Open loading door.
2.Pull off adhesive strips from inside machine on top of drum.
3.Remove foil hose and polystyrene padding from the machine.
