Operating Instructions
32

If the washing results are not satisfactory

If the washing has turned grey and if limescale is deposited in the
drum, then
Too little detergent was used.
The wrong detergent was used.
Special soiling was not pre-treated.
Program or temperature not set correctly.
If multi-component detergents are used, the individual components
were not used in the correct ratio.
If there are still grey spots on the washing,
Washing soiled with ointments, grease or oils was washed with too
little detergent.
Too lower temperature was used for washing.
A frequent cause is that softener - particularly that in concentrated
form - has reached the washing. Wash out such spots quickly and use
the softener concerned carefully.
If at the end of the last rinse foam is still visible
Modern detergents can also cause foam in the last rinse. However,
the washing is still sufficiently rinsed.
If there are white remnants on the washing
These are insoluble components of modern detergents. They are not
the result of an insufficient rinsing effect.
Shake or brush out the washing. In future, perhaps you should turn
the washing inside out before washing it. Examine your choice of de-
tergent and if necessary use liquid detergent.

Carrying out emergency drainage

If the washing machine no longer pumps off the washing solution,
emergency drainage must be performed.
If the washing machine is in a room where there is a risk of frost,
emergency drainage must be performed if there is a possibility of
frost.
In addition: unscrew the inlet hose form the water tap and place it on
the floor. Empty the drainage hose.
1 Warning! Switch off the washing machine before performing emer-
gency drainage and pull out the mains plug.