Installation and connection instructions
2.Pull both hose holders off the
unit with a strong pull.
3 | The special key E and the caps D |
| (2 each) and G (1 each) are sup- |
plied with it.
3. Unscrew the two screws with the special spanner.
4. Unscrew the 4 screws B with spe- cial spanner E.
5. Remove the transport rail C.
6. Screw the 4 screws B back in.
7. Close the 2 large holes with the caps D.
Important! Press in the caps with sufficient strength so that they engage in the rear panel (protects the inside of the units against splash water).
8. Remove the screw F, including the compression spring, with the spe- cial spanner E.
9. Close the hole with the cap G.
Important! Press in the cap with sufficient strength so that it en- gages in the rear panel (protects the inside of the unit against splash water).
37
