AeroGarden 300177AA manual Directions for Replacing AeroGardenTM Pump, Removing Old Pump

I N T E R N A T I O N A L , I N C .

Directions for Replacing AeroGardenTM Pump

Grow Surface	Grow Surface
	Opening

Upside Down Grow Surface:

	Pump Cover Plate
Filter		Pump
		Tower

Tools Needed:

•Flat-head screwdriver

•Phillips-head screwdriver

•Needle-nose pliers

Bowl View Door

Wire Slot

Removing Old Pump

1Unplug AeroGarden.

2Remove the Bowl from the Base. Do not empty the water.

3Remove the Grow Surface from the Bowl and place on a counter covered by a towel (your roots will be

dripping with water).

Hint: Lift the View Door and slide one hand into the Bowl to lift. Don’t worry if you gently tear some roots.

4Gently remove each plant from its Grow Surface Opening and place the plants upright in the Bowl so that

the roots are in the water.

Hint: Note where the plants were positioned on the Grow Surface.

5Turn the Grow Surface upside down on the towel, with the back of the Pump Tower facing you. (see top right photo)

6Take out Pump Filter, rinse it (no soap) and set it aside.

7Remove the Pump Connector Screw in the Pump Connector using a Phillips-head screwdriver.

8Pull up on Pump Connector to disconnect it from the bottom of the Grow Surface.

9Remove Pump Cover Plate – insert flat-head screwdriver into each of the 3 rectangular slots and turn screwdriver 90 to help pry out the cover plate. It is okay to use force.

Pump

Connector

Wire

Pump

Connector

Screw

Pump

Connector

Pump

10Remove the Pump by inserting the flat-head screwdriver into the space under the pump. Push down on the handle of the screwdriver to lift the Pump out of the Pump Tower.

11Pull wire out of Wire Slot. Discard old Pump in trash.

Part A

12Remove part A with needle-nose pliers and discard in trash.

Directions continued on back