Pod 1 channel 0 can be configured to view any one of the four
PCI interrupts. Move the jumper so that it corresponds to the
desired interrupt and that interrupt line will be routed to POD 1
channel 0. The jumper and interrupt stake pins are clearly
labeled and are located under POD 7.
Viewing the interrupts
Interrupt Jumper
Pod 0 Channel 1 INT
I I I I
N N N N
T T T T
A B C D
Configuring the front panel switches and LEDs
Switch Setting LED
Parity On Parity Checking
enabled ON
Parity On Parity checking
disabled OFF
No Wait No Wait cycles
acquired ON
No Wait All Wait cycles
acquired OFF
No Idle No Idle cycles
acquired ON
No Idle All Idle cycles
acquired YES
TDO/TDI TDO connected to
TDI No LED, switch in
rightmost position
TDO/TDI TDO not connected
to TDI No LED, switch in
leftmost position
State/Timing State ON
State/Timing Timing OFF
10