ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(1)Pliers
(1)Hammer
(2)7/16" Open or Boxed End Wrenches
1.Remove the spreader, the loose parts and the hard- ware package from the carton. Lay out parts and hardware and identify. Refer back to figures 1 and 2.
2.With the spreader resting upside down on the top of the hopper, assemble a spacer and then a 1/2" flat washer onto each end of the axle. See figure 3.
AXLE
SPACER
1/2" FLAT WASHER
FIGURE 3
3.Place a wheel onto the end of the axle that has no cross hole. The long end of the hub goes to the inside. See figure 4.
4.Place a 1/2" flat washer onto the axle and then lightly tap a hub cap onto the axle until it is snug against the washer and wheel hub. See figure 4.
NO CROSS HOLE
WHEEL
1/2" FLAT WASHER
HUB CAP
FIGURE 4
5.Place a wheel onto the end of the axle that has a cross hole. The long end of the hub goes to the inside. See figure 5.
6.Assemble a 5/32" x 2" cotter pin through the notched wheel hub and the axle. See figure 5.
7.Lightly tap a hub cap onto the axle until it is snug against the wheel. See figure 5.
5/32" x 2"
COTTER PIN
HUB CAP
CROSS
HOLE
WHEEL
FIGURE 5
8.Remove the 1/4" hex bolt, flat washer and hex lock nut from the center of the crossover tube. See figure 6.
CROSSOVER
TUBE
1/4" HEX BOLT
SHAFT
SUPPORT
1/4" FLAT
WASHER 1/4" HEX LOCK NUT
FIGURE 6
4