23.Assemble the flow control gage onto the flow control mounting bracket using a 1/4" x 3/4" carriage bolt, a nylon washer and hand knob. See figure 14.
24.Move flow control arm to off position and push flow control mounting bracket toward hopper until closure plate (located in bottom of hopper) is completely closed. Tighten 1/4" hex lock nuts assembled in step 21. See figure 14.
HAND KNOB |
|
NYLON | OFF |
WASHER |
|
FLOW CONTROL |
|
GAGE |
|
1/4" x 3/4" |
|
CARRIAGE BOLT |
|
| 1/4" HEX |
| LOCK NUTS |
| FLOW |
| CONTROL |
| MOUNTING |
| BRACKET |
FIGURE 14
25.Lubricate as instructed in the lubrication section on page 8.
7