9.Place the handle tube (long) on the crossover tube, (side between crossover tube and hopper), align the holes in the handle tube, crossover tube, and shaft support. Assemble with 1/4" hex bolt, flat washer and hex lock nut removed in the previous step. See figures 6 and 7. DO NOT TIGHTEN AT THIS TIME.
10.Assemble two handle braces to the inside of the hopper frame, one each side, using two 1/4" x
TIGHTEN AT THIS TIME.
11.Align the holes in the ends of the two handle braces with the hole nearest the middle of the handle tube assembly. Secure with a 1/4" x
12.Tighten all hex lock nuts and bolts, following same sequence as assembled in the previous three steps. See figure 7.
HANDLE TUBE (LONG)
HEX BOLT 1/4" x
HITCH
BRACE HEX BOLT 1/4" x
1/4" HEX BOLT
1/4"
LOCK
NUT
CROSSOVER
TUBE
FLAT WASHER
SHAFT SUPPORT
1/4" HEX
LOCKNUT
FIGURE 7
13.Assemble the leg stand tube to the handle tube (long) using two 1/4" x
14.Place a vinyl cap over the end of the leg stand tube. See figure 8.
HANDLE TUBE (LONG)
1/4" x
HEX BOLTS
1/4"
LOCK
NUT
VINYL CAP | LEG STAND TUBE |
FIGURE 8
15.Assemble the flow control link (the end with the small hole) to the flow control arm using one 1/4" x 5/8" hex bolt and one 1/4" lock nut. Do not over tighten. The flow control link must pivot freely. See figure 9.
16.Place the vinyl grip on the flow control arm. See figure 9.
VINYL GRIP
FLOW CONTROL
LINK FLOW CONTROL
ARM
1/4" HEX
LOCK NUT
1/4" x 5/8"
HEX BOLT
SMALLEST HOLE
FIGURE 9
5