17.Assemble the flow control arm to the flow control mounting bracket using one 1/4" x 5/8" hex bolt and one 1/4" lock nut. Do not over tighten. The flow control arm must pivot freely. See figure 10.
18.Hook one end of extension spring through small hole near bend in flow control rod and the other end through hole in flow control mounting bracket. See figure 10.
FLOW CONTROL ARM | FLOW | |
CONTROL | ||
| ||
FLOW CONTROL | LINK | |
| ||
MOUNTING BRACKET |
|
20.Hook free end of flow control rod through hole in slide gate bracket located near bottom of hopper. See figure 12.
SLIDE
GATE
HOPPER BRACKET
FLOW
CONTROL
ROD
FLOW
CONTROL
ROD
EXTENSION
SPRING
1/4" HEX LOCK NUT
FIGURE 10
1/4" x 5/8"
HEX BOLT
FIGURE 12
21.Assemble flow control mounting bracket and the handle tube (short) to the handle tube (long) using two 1/4" x
TIME.
22.Place handle grip on each handle tube. See figure 13.
19.Place a 5/16" flat washer over the end of flow control rod, and insert end of rod through slot in flow control mount bracket and through the hole in flow control link. Secure with a 3/32" x 3/4" cotter pin. See figure 11.
FLOW
CONTROL
ROD
EXTENSION | FLOW |
SPRING | |
| CONTROL |
| LINK |
5/16" FLAT
WASHER
FLOW CONTROL | 3/32" | |
COTTER | ||
MOUNTING BRACKET | ||
PIN | ||
| ||
FIGURE 11 |
|
HANDLE GRIP | FLOW CONTROL |
1/4" x | MOUNTING BRACKET |
| |
HEX BOLTS |
|
5/16"
HANDLE FLAT
TUBE WASHERS (SHORT)
HANDLE | 1/4" | |
LOCK | ||
TUBE | ||
NUTS | ||
(LONG) HANDLE GRIP |
FIGURE 13
6