ENGLISH
IMPORTANT: Do not over bend the support rods during the following step. Over bending will cause the steel rods to loose supporting tension.
10.(Figure 17) Tip the hopper onto it's back to assemble the two hopper support rods. Place the ends of each rod into the upper and lower rear hopper tubes, bending the rod just enough to fit into the holes in the tubes.
17
SUPPORT
RODS
11.(Figure 18) Insert a 3/8" x 3" clevis pin (R) through the lower hole in each upper hopper side tube. Next assemble a bag arm tube onto each clevis pin and secure it with a 3/32" hair cotter pin (N).
12.(Figure 18) Assemble a vinyl cap (V) onto the end of each bag arm tube.
| 18 |
LOWER HOLE | 3/32" HAIR |
| COTTER PIN (N) |
| 3/8" x 3" |
VINYL CAP (V) | CLEVIS PIN (R) |
| BAG ARM TUBE |
13.(Figure 19) Secure the rope to the top center of the hopper bag frame.
19
14.(Figure 20)To assemble the hopper bag to the sweeper, slide the ends of the bag arm tubes into the ends of the sweeper's hitch tubes and secure with two 1/4" x
BAG ARM TUBE | 20 |
3/32" HAIR | 1/4" x |
COTTER PIN (N) | CLEVIS PIN (Q) |
10