ENGLISH

8.Assemble the hitch bracket to the front tongue using two 3/8" x 1" hex bolts (B), and 3/8" hex lock nuts (M). Tighten. See fi gure 4.

9.Assemble the leg stand bracket to the front tongue using two 5/16" x 1" hex bolts (C) and 5/16" hex lock nuts (L). Tighten. See fi gure 4.

LEG STAND

BRACKET (B) 3/8" x 1"

HEX BOLT

(C) 5/16" x 1"

12.Assemble a wheel with the valve stem facing out onto the axle.Assemble a hub cap (Q) by pressing or tapping it onto the axle. Repeat on other end of axle. See fi gure 6.

WHEEL

AXLE

HEX BOLT

HITCH BRACKET

(Q) HUB CAP

FIGURE 6

FRONT

TONGUE

(L) 5/16" HEX

LOCK NUT(M) 3/8" HEX LOCK NUT

FIGURE 4

10.Place the front tongue inside the rear tongue as shown in fi gure 5. Fasten the tongues together using a 3/8" x 4" hex bolt (A) and a 3/8" hex lock nut (M). Tighten, leaving the nut just loose enough that the tongues can pivot freely. See fi gure 5.

11.Insert the 3/8" x 4" clevis pin (G) through the tongues and secure with a 1/8" hairpin cotter (N), as shown in fi gure 5.

FRONT

(N) 1/8" HAIRPIN

TONGUE

COTTER

(M) 3/8" HEX

LOCK NUT

(G) 3/8" x 4"

CLEVIS PIN (A) 3/8" x 4"

HEX BOLT

13.Turn the wheel support over to rest on the wheels. Place the latch stand bracket onto the tongue, sliding it underneath the latch lock. Turn the latch stand plate as shown in fi gure 7. The tabs at the ends of the channels must face the rear. Place the latch stand plate down onto the latch stand bracket. See fi gure 7.

TAB AT

REAR

LATCH

STAND LATCH

PLATE STAND LATCH

BRACKET LOCK

FIGURE 7

14.Place the poly tray down onto the wheel support and the latch stand plate. Fasten the tray to the wheel support using eight 5/16" x 3/4" truss head bolts (F) and 5/16" hex lock nuts (L). Fasten the tray to the latch stand plate and latch stand bracket using four 1/4" x 1" hex bolts (E), 1/4" fl at washers (J) and 1/4" hex lock nuts (K). Do not tighten yet. See fi gure 8.

FIGURE 5

6