14.Slide a rear hopper tube (11) onto the two upper hopper tubes (6). See figure 10.
15.Secure the upper hopper tubes (6) to the rear hopper tube (11) using two 1/4" x 1" curved head bolts (26) and 1/4" nylock nuts (24). See figure 10.
NOTE: Hopper bag (3) not shown for clarity.
26
11
24
6
26
24
6
figure 10
16.Slide the bag frame tube (1) through the front flap of the bag. See figure 11.
17.Secure the bag frame tube to the bottom hopper tubes using two 1/4" x 1.11" clevis pins (28) and 3/32" cotter pins (19). See figure 11.
18.Secure the top and bottom hopper tubes together using two 5/16" x 3/4" hex bolts (17) and 5/16" nylock nuts (21). See figure 11.
21
17 19
2817
21
1
19
28
figure 11
19.Using a hammer, tap a palnut (23) onto one end of the pivot rod (2). See figure 12.
20.Slide the end of the pivot rod that doesn't have a palnut on it through the holes in the side of the upper hopper tubes and through the middle flap of the bag. See figure 12.
21.Using a hammer, tap a palnut (23) onto the other end of the pivot rod (2). See figure 12.
2
23
2
figure 12
22.Insert the hopper support rods (7) into the holes in the upper hopper tubes and then into the rear bottom hopper tubes as shown in figure 13.
NOTE: The hopper support rods will bend about as much as shown in figure 13 when they are assembled.
7
7
figure 13
6