ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1)Pliers

(2)7/16" Wrenches

(2)1/2" Wrenches

CAUTION: PARTS OF TRACTOR

MAY BE HOT! MAKE SURE ENGINE

AND MUFFLER ARE COOL BEFORE

INSTALLING SPREADER!

1.Turn the spreader upside down as shown in figure 1.

2.Assemble two angle brackets and two 1/4" nylock nuts onto the ends of the longer bolts already assembled to the frame tube. Do not tighten yet. See figure 1.

1/4" NYLOCK NUT

ANGLE

BRACKET

FIGURE 1

3.Fasten deflector to angle brackets using two 1/4" x 3/4" hex bolts, 1/4" flat washers and 1/4" nylock nuts. Allow angle brackets to swivel so deflector curves naturally between angle brackets and then tighten all nuts. See figure 2.

DEFLECTOR

1/4" x 3/4"

 

HEX BOLT

1/4" FLAT WASHER

1/4"

NYLOCK NUT

FIGURE 2

4.Insert agitator hairpin into middle hole in the spreader shaft. Assemble a seal (turned as shown in figure

3) onto end of the spreader shaft closest to hairpin agitator. See figure 3.

5.Slide end of spreader shaft having the seal through the plastic bushing in the bottom of hopper. See figure 3.

6.Slide the impeller onto the spreader shaft and secure it with a 1/8" x 1-1/4" cotter pin. See figure 3.

AGITATOR

 

HAIRPIN

SPREADER

 

 

SHAFT

 

SEAL

IMPELLER

1/8" x 1-1/4"

COTTER PIN

FIGURE 3

7.Assemble a seal (turned as shown in figure 4) onto the motor shaft. Slide it up against the motor.

8.Assemble the impeller coupler onto the motor shaft and secure it with a 1/8" x 1-1/4" cotter pin. Spread the ends of the pin around the coupler. See figure 4.

 

SEAL

1/8" x 1-1/4"

 

COTTER PIN

IMPELLER

 

COUPLER

FIGURE 4

4