9.Place screen down into hopper. DO NOT place it under the clips in bottom of hopper at this time. See figure 6.

10.Place motor assembly down into hopper, inserting end of spreader shaft into impeller coupler. Secure it with a 1/8" x 1-1/4" cotter pin, spreading ends of pin around coupler.

See figure 5.

11.Fasten motor mount bracket to hopper using four 5/16" x

1" hex bolts, 5/16" flat washers, nylon washers and 5/16" nylock nuts. See figure 5.

14.Attach the control mount tube to the top of the spreader using a 5/16 x 1" hex bolt and 5/16" nylock nut. See figure 7.

NOTE: The end of the control mount tube with the smaller bend should be attached to the spreader.

5/16" x 1"

HEX BOLT

MOTOR

ASSEMBLY

5/16"

NYLOCK NUT

NYLON

WASHER

5/16" x 1"

HEX BOLT

5/16" FLAT

WASHER

1/8" x 1-1/4"

COTTER PIN

SPREADER SHAFT

SCREEN

5/16" NYLOCK NUT

FIGURE 7

FIGURE 5

12.Lift screen up and slide seal down spreader shaft to rest against plastic bushing in bottom of hopper. See figure 6.

13.Slide one edge of the screen under one of the clips. Then, slightly bow the screen to slide the opposite side of the screen under the other clip. See figure 6.

CLIP SCREEN SHAFT

SEAL

BUSHING

CLIPS

FIGURE 6

15.Attach the flow control to the control mount bracket using a 5/16" x 1" hex bolt and a 5/16" nylock nut.

See figure 8.

5/16" x 1"

HEX BOLT

5/16" NYLOCK NUT

FIGURE 8

5