ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1)Hammer

(2)7/16" Wrenches

(2)1/2" Wrenches

Lay out and identify parts and hardware using the illustrations on pages 2 and 3.

STEP 1: (SEE FIGURE 1)

•Remove pre-assembled 1/4" nylock nuts and spacers from inside of hopper tubes. Discard spacers once removed. Set aside 1/4" nylock nuts for use in step 2.

SPACER

PRE-ASSEMBLED 1/4" NYLOCK NUT

FIGURE 1

STEP 2: (SEE FIGURE 2)

•Attach the RH hitch support tube (2) and LH hitch support tube (3) to the inside of the hopper tubes using pre-assembled bolts, two 1/4" x 1-1/2" hex bolts (12), and four 1/4" nylock nuts (16). Do not tighten yet.

12

16

FIGURE 2

STEP 3: (SEE FIGURE 3)

•Press a tube plug (25) into the hitch tube (5).

•Assemble the back holes in the hitch tube (5) to the hitch support tubes using two 1/4 x 2" hex bolts (56) and 1/4" nylock nuts (16). Tighten all nuts and bolts assembled up to this point.

25

56

16

5

56

FIGURE 3

4