
Correcting or changing an ID setting:
In order tocorrect a programming error, the entrance station(s) and the tenant station(s) must be cleared of their incorrect program data, then programmed again correctly. Follow these steps to clear:
1.Put the system into programming mode using the procedure described on page 1, step 3.
2.At the tenant station, press and hold the door release button and bell button simultaneously until a beep is emitted from the unit (should take about 3 seconds). The internal memory is now cleared.
3.If using the
4.You can now
Programming multiple entrance stations / Concierge stations via Link Data:
If your system has more than one entrance panel and/or you’re using the
Using the keypad | Using the supplied software: |
and scroll module: |
1.Import the data from the
2.Export the data you just imported to each of your other
Note: The
- 3 -