Aiphone IME-150, Iai-100, IME-100 Installation of the acoustic interface tube fixer English

4-4
1
[1]		[2]	[6]
			[6]
		[3]
		[4]
	[5]
2	[7]	[10]
	[8]
[9]		[11]
4
Not use connector
		Red
		Cut
		[12]	[12]
	Change	Blue
		Red
		[13]	[13]
		Blue
		Red	[14]
		[14]
		Blue
	Change		[16]
Not use connector		Red
			[15]
		[15]
		Cut
		Blue

Installation preparations for the acoustic interface English

[1]Fixing base

[2]Slit plate

[3]Microphone

[4]Acoustic output

[5]Acoustic tube main unit

[6]Sound I/O opening

[7]Driver unit

[8]Cover

[9]Acoustic tube holes

[10]Driver main unit

[11]Rubber seal

[12]Upper acoustic tube (2)

[13]Upper acoustic tube (1)

[14]Acoustic I/O tube

[15]Lower acoustic tube

[16]Microphone cord

1.When the installation position is on the left as seen from the customer side, the acoustic I/O tube can be installed unchanged from its shipped configuration. When installing it on the right, while referring to the diagram, reverse the left/right direction of both slit plates of the acoustic I/O tube so that the direction of the sound I/O opening (slit) is reversed.

2.Open the driver unit cover, and remove from inside the driver main unit. Attach the chassis to the glass, and then reinstall the driver main unit and cover. The acoustic tube can also be connected on the right side. In this case, install the driver main unit on the reverse side. Use metal cutters to cut the joints on the side where you wish to make the hole.

Do not forcibly rip with pliers as it could deform the surrounding area.

3.Clean the location where the acoustic tube will be installed and the surrounding glass with standard cleaning fluid.

Some types of barrier glass are made of plastic, so do not use a detergent that could damage the plastic. Also make sure it will not affect the surrounding sealant.

4.Referring to the diagram, draw a guideline on the glass from the top to the bottom to make sure that the acoustic tube is attached vertically.

1. Upper and lower sections are connected together to assemble the acoustic interface, so it is important that it is exactly vertical.

2. Do not change the position measurements because it could result in the length of the acoustic tube being insufficient.

4-5

[1]

Guideline

[2]

[3]

Installation of the acoustic interface (tube fixer) English

[1]Double-sided tape

[2]Set screw

[3]Counter sash, etc.

1.The tube fixer secures the bottom of the lower acoustic tube. Secure on the customer side of the counter with the screw provided and double-sided tape.

2.Temporarily insert the acoustic tube, align the position with the guideline, and make a pilot hole in the counter.

3.When deciding the position, it is necessary to take into account the extra thickness caused by the double-sided tape on the tube fixer and acoustic tube. In addition, the 2mm thickness of the tube fixer itself must be taken into account.

4.When the position is determined, attach to the counter with the

double-sided tape, and then secure with the set screw.

- 8 -