Aiphone IP EWST-POE

Scheduled Events

• Description - Enter a description of the event

• Command - Select a pre-existing command from the list or select the <Create/Edit

Command> entry to bring up the Maintain Commands dialog

• Intercoms - The All Active is the only option available at this time

• Prompted - Check this box to pop up a dialog when the scheduled event occurs

• Allow Cancel - Check this box to add a Cancel button to the prompted dialog. This will

allow the operator to cancel the scheduled event

• Continue if no response after 30 seconds - Check this box to allow the command to

automatically continue without having the operator press the OK button on the prompted

dialog

• Days of Week - Check each day of the week that this command is to be scheduled for

• Time of Day - Select the time that the command is to run

• Retry? - Check this box to turn on automatic retry. Scheduled commands may not run for

two different reasons. First, if there is an active conversation or a call in the Calls Waiting list

is less than 60 seconds old, a Scheduled Command will not start. Secondly, a command

may start, but fail to successfully complete due to a missing dependency (e.g. Forward

command to a TalkMaster PC that is not available). If either or both of these failures occur ,

and the Retry? box is checked, the system will automatically retry the command based on

the following parameters.

• Times - Enter the number of times to retry this command

• Every - Enter the amount of time between each attempt

• Close TalkMaster on Start failure - Check this box to automatically terminate

TalkMaster if the command is unable to be started after the requested retries have been

reached. This will force the Intercom to disconnect and attempt to connect to any Fail

Forward addresses that have been configured in the Intercoms.

• Close TalkMaster on Command Failure - Check this box to automatically terminate

TalkMaster if the command has not successfully executed after the requested retries

have been reached. This will force the Intercom to disconnect and attempt to connect to

any Fail Forward addresses that have been configured in the Intercoms.

• Inactive Entry - Check this box to deactivate this event without deleting it from the schedule