|
| (orange) (green) |
Input the master code twice. |
| Illumination Blinking |
(Default : | ) | Bleep, Bleep |
Français English
Setting the key illumination time | Setting the relay output time |
(Default: 10 Sec.) | (Default: 3 Sec.) |
| When setting relay 1 When setting relay 2 |
Reset Settings | External output setting | |
(Default: OFF) | ||
|
Nederlands
Input the setting code. | Input the setting code. | Input the setting code. |
Illumination Blinking | Illumination | Blinking |
Bleep |
| Bleep |
Input the setting code.
Illumination Blinking
Bleep
Input the setting code.
Illumination Blinking
Bleep
During | During forced | During lockout | OFF |
and forced | |||
Lockout | entry output | entry output |
|
Inputting of illumination time | Inputting of relay output time |
|
| |
(ex.: 20 seconds) | (ex.: 99 seconds) |
|
| |
10 - 99 | 01 - 99 |
|
| |
Indicator is lit up at all times: 00 | Latched (※) : 00 |
|
| |
Illumination Blinking | Illumination Blinking | Illumination Blinks three times | Illumination Blinking | |
Bleep, Bleep, Beep | Beep | |||
Beep | Beep | |||
|
|
- When the |
| key is pressed, the green LED lights up, the buzzer beeps twice, and the system exits the setting mode. | Indicator | Blinking | |||||
| |||||||||
| goes out | ||||||||
(If the |
| key is included in the user code and the master code, the system does not exit the setting mode.) |
|
|
|
|
| ||
|
|
|
|
|
| Bleep, | |||
- You can continue the setting up operation by entering an arbitrary setting code. |
|
|
|
|
| Bleep | |||
|
|
| |||||||
|
|
| |||||||
|
|
|
|
|
| ||||
·(※) If the latched status has been set and the door is unlocked, it will not be locked again until the user code is entered (or the request to exit/entry button is pressed, or
the 
key is pressed while
·When the door is unlocked during relay outputting (including when latched), the system cannot be switched to the setting mode.
·If the power is turned off and
the 
, 
, and 
keys are pressed simultaneously while the unlock 1 input status is active (short circuit between terminals PB1 and C), the settings can be returned to their default values by turning the power back on and
pressing the 
, 
, and 
keys simultaneously for 3 seconds.
·When setting the external output, do not set the relay 2 output to be latched.
9
