Mounting
1.Detach the door station from the flush mount back box by removing the screws with the special screwdriver that is supplied with the unit.
2.Attach the flush mount back box to the wall.
3.Route wiring through the flush mount back box and connect wires to the door station.
*See page 5 and 6 for details on wiring and connections.
4.Attach the door station to the flush mount back box.
*Be sure to use the original screws to reattach the door station to the flush mount back box.
English Français
114 mm
Flush mount back box
Using the transparent nameplates
Inserting the transparent nameplates
1 Remove the door station from the flush mount back box. 2 Peel off the protective seals on the plate (both sides).
3 Fill in the name of the resident on the transparent nameplate.
Nederlands
Door station
Transparent nameplate
Special | Loosen |
screwdriver |
|
| Tighten |
263 mm
45 mm
Special screws (4 pcs)
Be sure to leave 25 mm (1") of white space on the left end to account for insertion.
4 Insert the
with 
in diagram).
25 mm
(1")
ABC | To |
insertion | |
opening |
Wall
Notes on handling wires
•After stripping back the cable jacket from the conductors, waterproof the area that has been cut by wrapping insulation tape around the end of the jacket. Additionally, position
the cable downward to prevent rainwater or moisture from seeping into the cable.
•Do not bend the wires at a sharp angle to prevent them from breaking as they age.
Areas where the cable jacket was removed
Do not bend at a sharp angle.
Flush mount back box
PART NAMES
Video door station
Access control keypad
Special screws for panel mounting
Camera
Microphone
White light LED
Speaker
Directory card
Call button
LED indicator (Orange)
LED indicator (Green)
Keys (Yellow)
Special screws for panel mounting
4
