Light |
Slot |
Tab |
Figure 10 |
SECTION 6
Completing the Installation
1.Insert the plug from the heating unit into the receptacle marked “HEAT”, and the plug from the fan into the receptacle marked “VENT”(Figure 11).
Post |
Hole |
Post |
Figure 13 |
4.Attach light reflector in place with the two screws removed during Step 2 in SECTION 1 Preparing the Unit so grill fits snuggly against ceiling (Figure 14).
Heater
Vent
Figure 11
2.Remove grill from carton and open light lens area by pushing in on the two tabs of the light lens and pulling outward from lens. The lens will swing open on the connector bars. DO NOT remove the lens from the grill (Figure 12).
Connector Bar |
Tabs |
Figure 12 |
3.Install light reflector into grill by lining up the posts on grill with the holes in light reflector (Figure 13). Raise light reflector and grill up to housing and insert plug from light into receptacle marked “LIGHT” (located on the side of the wire compartment) and insert plug from night light into receptacle marked “NIGHT LIGHT” (Figure 11).
Screws |
Figure 14
CAUTION: FAILURE TO SECURE THE REFLECTOR SCREWS MAY RESULT IN A RATTLING OR HUMMING NOISE.
5.Install the appropriate bulbs (not included) specific to your model:
AK965L: Install a 100 watt maximum, type A19 medium base incandescent bulb (not included) and a 7 watt maximum type C7 (candelabra base) night light (not included).
WARNING: TO REDUCE THE RISK OF FIRE, USE ONLY TYPE
AK965FL: Install a high efficacy 26 watt maximum, 2 pin quad,
6.Close the light lens and secure in place by swinging back into position and snapping the tabs in place (Figure 15).
Connector Bar |
Tabs |
Figure 15 |
7.Restore power and test your installation.
965 Rev. A | www.airkinglimited.com | 4 of 12 |
