Airlink101 ASOHORL manual Hardware Installation

Installation

Installation the 10/100Mbps PCI bus Fast Ethernet Adapter requires Hardware installation first, then BIOS and Software installation.

Step 1, Hardware Installation

1.Switch off the computer, unplug the power cord, and remove the computer’s cover.

2.Select an unused PCI slot and remove its protective bracket.

3.Carefully insert the Adapter and press until all the edge connectors are firmly seated inside the slot. Then, screw the Adapter’s bracket securely into the PC’s chassis.

4.Attach the Wake-On-LAN cable (optional, for PCI 2.1 motherboard). If you require Wake-On-LAN capability, attach one end of the 3-pin Wake-On-LAN cable to the connector on the top edge of the Adapter, and the other end to the “WOL” connector on the computer’s motherboard. Refer to your computer’s installation manual to locate this connector.

5.Install the bracket screw, which secures the Adapter to the computer’s chassis.

6.Replace the computer’s cover and connect the network cable to the newly installed network Adapter. Reconnect the computer’s power cord and plug it into the power outlet.

6