Airlink101 ASW308P manual Introduction Connecting the Switch, Power, PoE Status

Ver. 1.0

Section 2

Quick Installation Guide

8-Port 10/100Mbps Switch with 4-Port PoE

Model # ASW308P

Package Contents:

• Switch with 4-Port PoE

• Power Adapter

• Rubber Feet Cushion (4)

• Quick Installation Guide

Section 1

Introduction

Connecting the Switch

Ports 1 - 4: These ports are PoE-enabled ports. Connect any PoE compatible device to these ports and the Switch will automatically supply power through these ports. If you connect a legacy device that is not PoE compatible, the Switch will not deliver power to the legacy device. This feature allows you to freely and safely mix legacy and PoE compatible devices on your network. The total power resource of the system is 30 watt sharing among the 4 PoE ports (maximum power per port is 15.4 watt).

Ports 5 - 8: These ports are standard Ethernet ports. Connect any legacy device to these ports.

Power Jack: Plug the supplied Power Adapter to the power jack to power on the Switch.

Thank you for purchasing the 8-Port 10/100Mbps Switch with 4-Port Power over Ethernet (PoE).

PoE delivers power and data through one single Category 5 (Cat-5) Ethernet cable, eliminating the need to have AC power available at every location of the end-devices such as WLAN access points, IP telephones, and IP cameras. PoE is already widely adopted in the market, saving up to 50% of overall installation costs by eliminating the need to install separate electrical wiring and power outlets.

The Switch can auto-transform between MDI-II or MDI-X type, so you can connect your network devices without worrying about using a standard or crossover Ethernet cable.

Please follow the instructions in this guide to setup the Switch properly.

Power

On: When the Power LED lights, the Switch is receiving power.

Off: When the Power LED is off, the Switch is not receiving power.

PoE Status

Green: A PoE device is connected and the port is supplying power.

Red: When the PoE port has the following problem:

•PoE power circuit shortage

•Power over PoE’s classification

•Out of PoE voltage range of 44 ~ 57 VDC output Off: No PoE device is connected.