E
EXTERIOR
E - 8
PATIO AWNING
OPERATION
NOTICE: The sliding entrance door must be shut to extend the awning, without this
happening the arm and the opening cover will contact the door. Once the awning is
extended the sliding door will open and shut fine without any interference.
1. TO EXTEND AWNING:
A. Adjust the crank handle to the required length. To adjust the crank handle,
twist the locking knob on the crank counter-clockwise to loosen. Extend
bottom portion of the crank assembly outward or retract inward to match
the required length. Twist the locking knob clockwise to tighten the crank
assembly. The crank is stored on the curbside lounge access door.
B. Hook the end of
the crank handle
into the gear as-
sembly loop of the
awning assembly.
Turn the crank
counter- clockwise.
Crank the awning
out far enough to
gain access to the
secondary support
arms.
C. Unlock flipper latch located on the support arm. Slide arm outward until the arm
is released from the support arm catch. Swing the arms downward and out of the
lead rail.
D. Adjust the support arm to the required
height and fasten by pulling up on the flip-
per latch.

Twist Locking knob to adjust length

Unlock flipper latch,

slide arm forward

Lock Unlock Lock
Gear
Assembly
Loop
Insert the end of
the crank handle into
the gear assemly loop
and turn counter-clockwise
to extend