G
PLUMBING
G - 8
GALLEY FAUCET
SERVICE
CAUTION: Always turn water OFF before remov-
ing existing faucet or disassembling the valve. Open
faucet handle to relieve water pressure and ensure that
complete water shutoff has been accomplished.
1. Remove red/blue plug bottom (3) from front of
lever handle, remove screw (2) and lever handle
(1). Unscrew handle screw (4) and lift off the handle
adapter (5) (with handle connector (6) attached).
2. Unscrew collar (9) being careful not to damage
the finish, lift out pivot retainer (10). Unscrew the
retainer nut using channel locks and remove the
O-ring (12) and bearing washer (13). Remove wash-
ers (7) and (8) from the cartridge stem
3. Pry out retainer clip (14) with flat bladed screwdriver.
4. Grasp cartridge stem with a pair pliers and pull
cartridge (15) straight up and out of body.
Reinstall has follows: Install cartridge (15) into valve
body with notched flat on stem facing forward. Be sure
to position the ears of the cartridge in the front and
back. Reinstall the retainer clip (14) that straddles the
ears on the cartridge. Continue reassembly by revers-
ing the steps discussed in steps 1-3.
Note: To service vacuum breaker assembly, (anti-si-
phon protection) the hose must be disconnected from
the threaded discharge prior to removing the spout
receptor (20).
To Correct reversed Hot and Cold Positions:
(It is necessary to shut off water supplies)
1. Position handle so that it points toward you.
Remove handle (follow instructions for SERVICE
step 1 only).
2. Turn cartridge stem so that the notch is turned ½
turn or 180 degrees.
3. Reinstall handle following SERVICE instructions.
1234
7
15
15
5
4
812
9
13
310
14
11
20
2
1Ear Clip
NotchTurn Stem
1/2 TurnNotched Flaton stem