SETTING THE CLOCK
CLOCK
1,3,5
2,4
When the AC cord is connected for the first time, the clock on the display flashes.
Set the time aa follows while the power is off.
1 Press the SET button.
The hour flashes.
2 Press the DOWN7 or UPA button to designate the hour.
3Press the SET button to set the hour.
The hour stops flashing and the minute starts flashing,
4Press the DOWNY or UPA button to designate the minute.
5Press the SET button to set the minute.
The minute stops flashing on the display and the clock starts from 00 second.
To correct the current time
Press the POWER button to turn the unit off. Press the SET
button and carry out steps 1 to 5 above.
To display the current time
Press the CLOCK button on the remote control. The clock is displayed for 4 seconds.
To switch to the 24-hour standard
Press the POWER button while pressing the UPA or DOWNY
button while the current time is displayed.
Repeat the same procedure to restore the
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs to be reset.
If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.
SETTING THE SLEEP TIMER
1
2
The receiver can be automatically turned off at a specified time.
Use the remote control.
1 Press the SLEEP button.
2 Press the UPF or DOWN< button within
four seconds to specify the time until the power is turned off.
Each time the button is pressed, the time changes between 5 and 240 minutes in
Specified time
To check the time remaining until the power is turned off
Press the SLEEP button once. The remaining time is displayed for four seconds.
To cancel the sleep timer
Press the SLEEP button twice so that “SLEEP on the display disappears.
15 ENGLISH
