WHEN THE “OVER LEVEL” INDICATOR LIGHTS UP

When input analog signals from the connected equipment are too high to accept, the OVER LEVEL indicator lights up. In this case, adjust the input level so that the indicator disappears.

To lower the sound level of the connected source

When the analog sound level of the connected source is higher than that of the FM and AM functions, adjust it as follows.

1 Select the function to be adjusted.

Turn FUNCTION and play the source.

2 Press TUNING Mrepeatedly.

The level is decreased as follows.

0 dB –6 dB –12 dB

To restore the previous level, press TUNING Nrepeatedly .

•When the analog output of the CD player or DVD player is 2 Vrms, set the level to –6 dB.

RECORDING AN AUDIO SOURCE

FUNCTION

FUNCTION

OPERATIONSBASIC

 

INPUT MODE

1 Select the program source to be recorded.

Turn FUNCTION (or press FUNCTION repeatedly).

2Set the tape deck or MD recorder to recording mode.3Start the selected program source.

NOTE

• Any sound control system has no ef fect on recording (see page 9).

•Input sound through the DIGIT AL IN terminals cannot be recorded. When recording the sound from the DVD, CD, MD or

LD player , connect the analog AUDIO OUT terminals of the

player to the corresponding AUDIO IN terminals of the receiver .

 

En

The sound will be recorded in 2 ch stereo.

 

• Input sound from the tape deck connected to the

TAPE IN

 

terminals cannot be recorded.

ENGLISH 11