TIMER
SETTING THE SLEEP TIMER
SLEEP
MULTI JOG
JOG +,-
SHIFT
The unit can be automatically turned of f at a specified time.
1Hold down SHIFT and press SLEEP on the remote control.“ SLEEP” is displayed.
2Within 6 seconds, press JOG + or - repeatedlyto set the sleep timer duration.With each press, the timer duration changes in
seconds, the current setting is entered automatically | . |
The unit turns of f after the selected time. |
|
• MULTI JOG on the unit is also available. |
|
Hold down SHIFT and press SLEEP on the remote control. The remaining time is displayed for 6 seconds.
To cancel the sleep timerHold down SHIFT and press SLEEP on the remote control repeatedly so that “ SLEEPoFF” is displayed.
GENERAL
CARE AND MAINTENANCE
Occasional care and maintenance of the unit is needed to |
| |
optimize the performance of your unit. | TIMER GENERAL | |
To clean the cabinet | ||
| ||
Use a soft dry cloth. |
| |
If the surfaces are extremely dirty , use a soft cloth lightly |
| |
moistened with mild detergent solution. Do not use strong |
| |
solvents, such as alcohol, benzine or thinner as these could |
| |
damage the finish of the unit. |
|
TROUBLESHOOTING GUIDE
If the unit fails to perform as described in these Operating Instructions, check the following guide.
GENERAL
There is no sound.• Is the AC cord connected properly?
• Is there an incorrect connection? ( ➞ pages
•There may be a short circuit in the speaker terminals.
➞Disconnect the AC cord, then correct the speaker connections.
•Was an incorrect function selected?
• Is SPEAKER set correctly? ( ➞ page 8) |
| |
Sound is emitted from one speaker only. |
| |
• Is BALANCE set appropriately? |
| |
• Is the other speaker disconnected? |
| |
| ||
Sound is heard at a very low volume. | En | |
• Has MUTING been pressed? | ||
| ||
An erroneous display or a malfunction occurs. |
| |
➞ Reset the unit as stated below . |
| |
TUNER SECTION |
|
• Is the antenna connected properly? ( ➞ page 6)
• Is the FM signal weak?
➞ Connect an outdoor antenna.
The reception contains noise interference or the sound is distorted.•Is the system picking up external noise or multipath distortion?
➞Change the orientation of the antenna.
➞Move the unit away from other electrical appliances.
To resetIf an unusual condition in the display window or malfunction occurs, reset the unit as follows:
1Press POWER 6STANDBY/ON to turn of f the power .
2Press POWER 6STANDBY/ON while pressing ENTER. Everything stored in memory after purchase is canceled.
If the power cannot be turned of f in step 1 because of a malfunction, disconnect the AC cord, and reconnect the AC cord after several seconds. Then carry out step 2.
ENGLISH 17